11 Mar Huntron Instruments — Series — User Manual The Tracker Series is a useful and efficient troubleshooting tool enhanced by the. Tektronix, Inc., P.O. Box , Wilsonville, OR – Huntron and Tracker are registered trademarks of Huntron, Inc. TR Service Manual. Including: huntron instruction, huntron operation maintenance, htr b1s maintenance, huntron htr b1s operator, huntron tracker htr

Author: Shaktinos Kazigrel
Country: Philippines
Language: English (Spanish)
Genre: Medical
Published (Last): 25 December 2016
Pages: 31
PDF File Size: 14.68 Mb
ePub File Size: 16.40 Mb
ISBN: 968-5-48947-821-2
Downloads: 8302
Price: Free* [*Free Regsitration Required]
Uploader: Kera

The Tracker with serial prefix 21A did not have the same oscillator as the older huntron tracker 1000 manual. Toggle navigation Huntron Support Forum. 1000, Many thanks for the responses, I am stuck, can not find a single component that is bad, but after removing and checking c17 and d4 the double dot has become a single dot and the horizontal and vertical controls have stopped responding.

HTR1005B-1S Schematic

May 02, Huntron tracker 1000 manual any suggestions for the horizontal sweep failure, i. The ‘extra’ fuse that is on the oscillator board is wired in series with the front panel common black jack. Here’s one that MAY work although I have to trcaker I’m not familiar manuak the oscilator in the B although the cost might not be worth it You can losing the sweep if they are excessively dirty. It is solid state.


Huntron Instruments Series Test Set User Manual

Another thing that just came to mind is to clean the range switches well. Sorry huntron tracker 1000 manual revive such an old post, but perhaps there are others who are looking for this information and would like an answer.

The symptom that they are bad is usually a single dot in the middle on the CRT indicating that the sweep in gone. You may need to trace the sinewave signal back from the oscillator section of the Tracker.

Obviously this will provide 60hz instead of huntron tracker 1000 manual, but it still functioned normally, as far as I could tell anyway.

I believe that rev J has some other circuitry that is causing this. I was a poor student at trackre time. I don’t remember the details, but If anyone is curious I will dig them up. I have worked this problem in the past by tapping the ac, stepping it down, isolating it huntron tracker 1000 manual running it to the signal transformer. J and unit serial no is 21A Somewhere your losing the horizontal sweep.

Sorry, the only diagrams I could find were the ones I posted earlier. Home Huntron tracker 1000 manual Search Login Register. Does anyone have a manuap for this board, or the service manual? Am I on the right track or is the Rev J pcb different?

It might not be a drop in replacement but it would get the unit 1000 again Hi Many thanks, this will help. Tracker 80HZ osc 6 Replies Views. Here is a link to a schematic diagram: And for a few bucks it was better than buying another Tracker.

Last Drivers  AP4313 PDF

The horizontal sweep huntron tracker 1000 manual like it is dead.

Tracker 1000 80HZ osc

At one point way back, there was an oscillator replacement kit for a while. I have the service manual for the older brown black model but the schematic is different, mine is gray. Toggle navigation Huntron Support Forum. May 07, Check for a sinewave into the signal transformer. I did this type of thing time and time again Can you suggest 1000 solution or a huhtron cause? Home Help Search Login Register. September 17, Use tuner cleaner if you have some.

Can’t find the 80Hz oscillator on this board. Huntron tracker 1000 manual not sure if this was a “test post” but I’ll reply anyway Not for nothing but I would think one would be able to find a suitable replacement somewhere to resurrect huntron tracker 1000 manual unit I may be able to find a schematic.


I will look into the Rev difference.