Burst Strength Attachment (ASTM D). Brochure Share. Request Info . Product Details Standards Get a Quote. Product Details. Burst Strength. ASTM D determines the measurement for bursting strength with a ball burst strength tester of textiles or garments that exhibit a high degree of ultimate. Page 1. — — 27 —>. Ø K-. k— ASTM D Fixture.
|Published (Last):||14 March 2014|
|PDF File Size:||10.66 Mb|
|ePub File Size:||4.63 Mb|
|Price:||Free* [*Free Regsitration Required]|
Other materials with astm d3787 test values may be used for this purpose. Link to Active This link will always route to the current Active version of the standard. Test Method D is considered satisfactory for acceptance testing of commercial shipments of textiles fabrics for bursting strength since the method astm d3787 been used extensively in the trade for acceptance testing.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Combining values from the two systems may result in nonconformance within the specification. If a bias is found, either the cause must be determined and corrected or astm d3787 test results must be adjusted astm d3787 consideration of known bias.
The kind of force transfer and strength that occur when knitted goods are worn is prevented by clamping astm d3787 as directed in this test method. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but ashm not provided as part of the standard.
The values stated in each system are not exact equivalents; therefore, each system may be used independently of the other. For the measurement of bursting strength with a hydraulic testing machine, refer to Test Method D This standard does not purport to address all of the safety concerns, if any, associated with its use. Historical Version s – view previous versions of standard.
In cases of disagreement arising from differences in values reported by the purchaser and the seller when using Test Method D for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the astm d3787 of the seller should be determined with comparison based on testing astm d3787 randomly astm d3787 from one sample of material of the type being evaluated.
Within the astm d3787, the inch-pound units are shown in parentheses. The test samples used should be as homogeneous as possible, drawn from the material from which the disparate test results were astm d3787, and randomly assigned in equal numbers to the laboratories for testing.
The test results from the two laboratories should be compared using astm d3787 statistical test for unpaired data at a probability level chosen prior to the testing series.